You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
Home > Inverter Support > IC Series Inverter/Charger Support > IC 2000 & 3000 Support > IC Series Inverter/Charger: AC WIRE SIZE AND OVERCURRENT PROTECTION
IC Series Inverter/Charger: AC WIRE SIZE AND OVERCURRENT PROTECTION
print icon

The wires used for the Input AC and Output AC must be sized to meet local electrical safety requirements. The AC wiring must be protected from short circuits and overloads by an overcurrent protection device. These requirements are usually met using a main panel and sub panel (with suitable circuit breakers/fuses installed) located before and after the Inverter/Charger as shown on pages the AC Wiring Articles.

 

CAUTION: The IC Series inverters’ internal transfer contacts are rated for 50 amps, The pass-through current for relay contact must be no greater than 50 amps or damage to this relay may occur.

Feedback
0 out of 1 found this helpful

scroll to top icon