IC-2000 Terminal block screws coming loose
# INTRODUCTION The Go Power! 2000 watt Inverter Charger 2000 delivers top features and performance at an economical price. It is a 3-in-1 system that expertly combines an inverter, battery charger and automatic transfer switch into one powerful and lightweight unit. The GP-IC-2000 has a compact footprint that saves s…
Inverter/Charger Remote Overview
# PRODUCT OVERVIEW This video covers the features and functions of the ICR-50 Inverter/Charger remote, including: * Inverter on/off functions * Charger on/off functions * LED symbols
IC Series Inverter/Charger: MOUNTING THE DRIP SHIELD
# MOUNTING THE DRIP SHIELD The IC Series Inverter/Charger is Marine UL listed. In order to properly mount the Inverter/Charger in a marine application, you must use a drip shield. Please follow the installation instructions below. **WALL MOUNT** ![][1] 1. Use the screws to mount the drip shield on the wall. ![][2…
IC Series Inverter/Charger: BATTERY TEMPERATURE SENSOR INSTALLATION
# Installation Steps The Battery Temperature Sensor (BTS) extends the life of the battery by preventing overcharging in warm temperatures and undercharging in cold temperatures. The BTS provides the Inverter/Charger with precise battery temperature information to automatically adjust the absorb and float charge volta…
IC Series Inverter Charger: BASIC SETUP
# **BASIC SETUP** Start the inverter first before plugging into shore power. If shore power is plugged in before the inverter is booted, if shore power is lost, the inverter will shut down. ## **Standby Mode** If the on/off switch on the inverter is applied when plugged into shore power and shore power is lost, the…
IC Series Inverter Charger: Unit Not Turning On
# How to troubleshoot the IC Series Inverter Charger The relays that allow pass through need power from the battery to operate. If the battery voltage has dropped below the Low Voltage Disconnect point on the inverter, it will not turn on and it will not pass power through and charge the batteries. To check the inco…
IC Series Inverter Charger: Lithium Battery Setup
# Battery Set Up To set your IC Series Inverter Charger to charge Go Power Lithium batteries, complete the following steps: • Go to Unit Setup and hit enter; • Scroll through unit setting to battery type and hit enter; • Scroll to Custom and hit enter; • Set absorption to 14.4 VDC and hit enter; • Set Float to 1…
IC Series Inverter Charger: Error Codes
# List of Error Codes Below are two tables that identify inverter error codes, and how to remedy them. Remote Error Codes PTOC (Over current protection) Pulling to much current from inverter Turn off loads, unplug from shore power, power cycle the inverter. Turn inverter back on and re-apply shore power OTP (Ove…
